Often you are starting- and runways with one white luminous centre line lights equipped. | A menudo están empezando- y cauces con uno blanco luminoso centro luces línea equipada. |
The centre line is considered to be part of the back court. | La línea del centro del campo es considerada parte de la pista trasera. |
The centre line of each outboard seating position of a bench seat shall be specified by the manufacturer. | El eje de cada plaza exterior de un asiento corrido lo especificará el fabricante. |
For operations in RVR of 400 m or less, centre line lights must be available. | En las operaciones con un RVR de 400 m o menos, debe disponerse de luces de eje de pista. |
The centre line of the femur load cell simulator (78051-319) shall be vertical with a tolerance of ± 0,5°. | El eje central del simulador dinamométrico del fémur (78051-319) deberá estar en posición vertical, con una tolerancia de ± 0,5°. |
The centre line of the femur load cell simulator (78051-319) shall be vertical with a tolerance of ± 0,5o. | El eje central del simulador dinamométrico del fémur (78051-319) deberá estar en posición vertical, con una tolerancia de ± 0,5 °. |
The measured drop points were referenced from the centre line of the rifle's bore (bore line). | La medición de los puntos de caída se referenciaba al centro del cañón del rifle (línea de eje de cañón). |
‘Torso line’ means the centre line of the probe of the 3-D H machine with the probe in the fully rearward position. | «Línea del torso», el eje central de la varilla del maniquí 3D-H, con dicha varilla totalmente desplazada hacia atrás. |
‘Torso line’ means the centre line of the probe of the 3 DH machine with the probe in the fully rearward position. | «Línea del torso» el eje central de la varilla del maniquí 3 DH, cuando dicha varilla está totalmente desplazada hacia atrás. 2.6. |
At the time of first contact the centre line of the impactor shall be within a ±10 mm tolerance to the selected impact location. | En el momento del primer contacto, el eje central del impactador coincidirá con el punto de impacto elegido, con un margen de tolerancia de ±10 mm. |
